Announcement

Collapse
No announcement yet.

AMC 360 ignition wire hook up

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • AMC 360 ignition wire hook up

    Can someone call out from the attached diagram which wire the pink ignition wire from the ProFlo-4 main harness should connect to?

    Thanks in advance.
    You do not have permission to view this gallery.
    This gallery has 1 photos.

  • #2
    Use a Voltmeter to Verify it has CONSTANT 12v on Run & during Cranking.
    Don't get too caught up in the numbers.
    Just give the Engine what it wants &
    Let the numbers be what they are.

    Jim McFarland....

    Comment


    • #3
      The "I" on the starter solenoid stands for Ignition.
      In my neighborhood, if you open your hood to check your oil, and the vehicle still runs after you close it.......Then your labeled the Neighborhood Mechanic.
      https://forums.edelbrock.com/filedat...?photoid=42773

      Comment


      • #4
        I don't have the battery hooked up as I'm still in installation mode and not ready to start ignition yet (coolant still out, etc...)

        So if I hook up to the F2 (Red W/T) wire just below the ECU harness - would that theoretically work?

        Comment


        • #5
          You have what's called a artificial Ignition wire.

          The RED/WHITE from the Key Switch is combined with the RED/WHITE from the Starter Solenoid...... Combined, they give you a Hot Wire ( Positive Battery Voltage ) when the Ignition key is in the Run, and Crank Position.

          You just need to Replace the section of wire that says "1.35 Ohms" with a regular wire.
          In my neighborhood, if you open your hood to check your oil, and the vehicle still runs after you close it.......Then your labeled the Neighborhood Mechanic.
          https://forums.edelbrock.com/filedat...?photoid=42773

          Comment


          • #6
            Like this picture:
            You do not have permission to view this gallery.
            This gallery has 1 photos.
            In my neighborhood, if you open your hood to check your oil, and the vehicle still runs after you close it.......Then your labeled the Neighborhood Mechanic.
            https://forums.edelbrock.com/filedat...?photoid=42773

            Comment

            Working...
            X