Announcement

Collapse
No announcement yet.

Correct cap for Pro-Flo 4 distributor

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Correct cap for Pro-Flo 4 distributor

    I have been trying to find the correct cap and rotor for the distributor that came with my system. The only part number that Edelbrock shows is the 22731 for the cap and 22733 for the rotor. These are not the ones that will fit my distributor. The cap 22731 is too short plus it mounts with threaded screws. The cap I have now mounts with the spring loaded L screws, no threads. Rotor is a slip on type but the replaced listed is the round rotor that mounts with screws. Can anyone please tell me the correct part numbers for the correct cap and rotor? I have searched the parts and the forum with no luck for the correct part numbers.

    Small block Chevy 350

    Thanks,
    Mike
    Last edited by Old School 350; 08-20-2020, 07:04 PM.

  • #2
    What engine family/size ?

    You need # for the cap ( with " J " hooks ) correct?

    You need the # the grey ( push -on ) rotor --correct ?

    Comment


    • #3
      I have this in my notes for the rotor:
      Alternative Replacements- AutoZone Duralast #F983 /FD308 std prods . /DR375A motorcraft.

      Comment


      • #4
        Originally posted by 2700 Cast View Post
        What engine family/size ?

        You need # for the cap ( with " J " hooks ) correct?

        You need the # the grey ( push -on ) rotor --correct ?
        Yes on both parts. I did finally find the correct part numbers. Cap #22732 and rotor #22734. It it for the Hall Effects type distributor used on the Pro-Flo 4 system.

        Thanks for all your responses!

        Comment

        Working...
        X