cam specs

[S10truggy]

just bought a pro flo 2 for a SBC 355ci, I was running stock tpi setup with over size injecters, but want a little more power.
the new motor is 10:1, with 2.02, 1.60 valve heads with double springs.
It will mostly be used for rock crawling so I want good idle and off idle response, but I also do a few mud runs, trucks pulls were I need the power most
what cam would u guys suggest?
thanks
Tim

[shaun callaway]

You can run with almost any cam of your choice.

The one recomendation that we do make is to have a cam with a 112 lobe separation.

[S10truggy]

finally getting around to getting this togther, fired up yesterday
only problem is I bought the kit used and the o-2 was missing and I forget to get one on ordered, in the parts list there is a NGK # but its not a good # was hoping to pick something up today at a parts store so I can try again tonight.
None of the speed shops up here have the Edelbrock one and said it will take a week to get.
Thanks
Tim

[shaun callaway]

If you go to the auto parts store and ask them for a 4 wire o2 sensor it should work just fine for you. Other than that there is our part number of 3591.