SlipNSlideVette
09-04-2009, 02:30 PM
I'm running Desktop Dyno 2003 and I was wondering how I should model this intake.
This is a simple program and obviously won't be dead on but has proven to be fairly close. Should I use:
"std design tunnel ram"
"tuned port injection"
"sequential fire injection"
"std single plane"
"single plane hi-flow"
(they also have dual plane and IR choices etc but I doubt those apply.)
(I believe if I understand their notes in the users manual that the sequential fire injection manifold is basically an LT1 style or similar, short runner intake. )
Just trying to have a good guess at all the right pieces before I dive in.
Thanks!
This is a simple program and obviously won't be dead on but has proven to be fairly close. Should I use:
"std design tunnel ram"
"tuned port injection"
"sequential fire injection"
"std single plane"
"single plane hi-flow"
(they also have dual plane and IR choices etc but I doubt those apply.)
(I believe if I understand their notes in the users manual that the sequential fire injection manifold is basically an LT1 style or similar, short runner intake. )
Just trying to have a good guess at all the right pieces before I dive in.
Thanks!